Page 1 of 1
Need a Fab shop in S D area
Posted: Wed May 28, 2008 7:48 pm
by FunJunkie
I need a good fabber for some tube work, I need to modify my bumper, there will be some chopping, capping, bending, and relocating some tubeing. Must have a bender and be able to comply with CAD design and specific measurements. Anyone or anywhere you know fit this bill? Cheap is nice but quality is a must. It should be 2 to 2.5 hours of work. After this job I have some more work needed but this will be needed in the next week or so.
Re: Need a Fab shop in S D area
Posted: Wed May 28, 2008 8:42 pm
by gon2srf
Where does Cowboy4x4 (Thomas) live? Anyone know? He builds some nice stuff.
Re: Need a Fab shop in S D area
Posted: Wed May 28, 2008 9:01 pm
by FunJunkie
I wish he was close, he's all the way in simi valley
Re: Need a Fab shop in S D area
Posted: Tue Jul 08, 2008 6:03 am
by FunJunkie
Just for future knowledge JackFab is the shizzle. if you need any fab work done in south bay I highly reccomend this shop.
Re: Need a Fab shop in S D area
Posted: Tue Jul 08, 2008 4:49 pm
by ecchamberlin
Hey, whats up? Long time no wheel with you.
TUBINGWORKS FAB FOR ANY FAB NEEDS 619 438 1160
This is Josh's shop and he does great work. He did a ton of bumper, slider and cage work on Mikey's 1st Gen 4Runner. Nice work. I have wheeled with this guy. Good people.
Re: Need a Fab shop in S D area
Posted: Thu Jul 10, 2008 8:45 pm
by FunJunkie
Hey wassup eric. true we need to get out again huh. Thanks for the info. I will look into his shop. I want to get steel fenders after Colorado next week.