HI-LIFT BASE
Posted: Fri Oct 26, 2012 5:54 pm
I have just made a protype hi-lift base. It's made from structural channel steel. The jack can be rotated 90 degrees in the base. I have contacted a local fabricator that is willing to build these for me, so the welds wil be prettier than mine. It is 8"x8" square. You will have to supply your own 1/2" pin. The cost will be $70.00 plus shipping. If you want one send me a PM.
These photos show the base being used to lift the front of my Dodge Ram with a Cummins engine:
These photos show the base being used to lift the front of my Dodge Ram with a Cummins engine: