Post
by OLLIE » Mon Jul 19, 2010 11:42 am
Steve,
I have never seen Grizzle Grip used. I have, however, seen Rhino Liner used. If I had a Jeep or vehicle of that sort, I would do it. It is quite effective and corrosion resistant. I assume all of thse products are similar in nature would all work well. The question is whether you want to apply it yourself or have it applied at place that does it professionally. Most of it is a two part epoxy that you can just roll on. If your rig is already gutted it would probably just be cheaper to do it yourself.
The only cautionary note I would say is that without carpet or some kind of insulation on the floor, the inside noise on the road will be higher. However, since it is a Jeep, you may not be consrned about that. That is not a poke at Jeep BTW.
"OLLIE"
(K6JYB)
APRS
K6JYB ("BugEater")
K6JYB-7 (VX-8R)
http://www.facebook.com/FJOllie
"Some people live an entire lifetime and wonder if they have ever made a difference in the world, the Marines don't have that problem."
-Ronald Reagan
CHECK OUT THE OUTDOOR ADVENTURE USA AMATEUR RADIO NET:
Every Thursday night at 7:30pm PST
Repeater
146.385+ PL: 146.2 Keller Peak (Echolink Equipped)