This was originally a generator trailer used on job sites and has a 3.5' x 5' x 2' box. Like many off-road trailers, it is overbuilt almost entirely out of box tube (with the exception of the more than adequate angle ribs supporting the floor). It has minimal surface rust, and is otherwise in excellent condition. It does lack any sort of suspension, but with the amazingly simple way the axle was mounted the frame is nice and clean - ready for any suspension setup we come up with. We're going to go the budget route on this, with an estimated total cost of $2,000 (including wheels/tires) once completed. It will be running the same wheel/tire combo I have on the Discovery, so that when I'm towing this I'll have a complete set of spares (4).
The plan is to add a raised floor over a 40-50 gallon water tank and water pump, and partition off about a foot of the front of the box for batteries and other on-board equipment. A kitchen box with stove, sink and propane tank will be built into one side. The other side will store a camp shower, toilet, tent, cot, table and chairs. The tongue will get a rack to carry 6 jerrycans of fuel, and the top will get a removable (probably) rack to hold a spare tire and a canoe. Running lights will be converted to submersible LEDs, and LED floodlights will be added all around to aid with nighttime camp setup, cooking, etc. I might also add solar (and/or wind) at some point to keep the batteries topped off.
Ideally, this leaves an approximately 3.5' x 4' x 1.5' easy-to-clean, multi-purpose cargo area open for whatever I might need to haul. I like the idea of keeping the open mesh gate and not filling up the entire trailer so I can still use it as a small cargo trailer when not camping. I'm also thinking about building the canoe rack a little wider than necessary so I can get full 4' x 8' sheets of plywood up there when needed.
